TESTING: REMOTE START RELAY HARNESS

1. UNPLUG UNIT FROM 3 PIN RELAY HARNESS AND 18 PIN MAIN PLUG (ON RS-102, RS-202, OR RS-602) ON RS-92 UNIT THIS IS A 12 PIN PLUG........ SET MODULE ASIDE.

2. TO TEST: TAKE (16GA.)WHITE WIRE FROM 3 PIN HARNESS AND HOLD TO GROUND......THIS WILL TURN ON IGNITION AS IF THE KEY IS ON...........MAKE SURE THIS WIRE IS HELD TO GROUND UNTIL THIS TEST IS COMPLETE.

3. NEXT TAKE THE YELLOW/BLACK (16GA.) WIRE AND TOUCH THIS WIRE TO A GROUND AND THE STARTER WILL ENGAGE........IF THE WHITE WIRE IS STILL HELD TO GROUND THE AUTO SHOULD STAY RUNNING. ONCE AUTO STARTS REMOVE THIS YELLOW/BLACK WIRE FROM GROUND AND THE STARTER SHOULD DISENGAGE..................AND THE VEHICLE SHOULD REMAIN RUNNING.

4. NEXT, WITH AUTO RUNNING, TO TEST ACCESSORIES ,TAKE THE WHITE/BLACK (16GA.) WIRE AND HOLD TO GROUND, WITH THE HEATER BLOWER MOTOR SWITCH IN THE ON POSITION, THE HEATER SHOULD BE RUNNING.

5. IF ALL OF THESE TESTS WORK, THE RELAYS ARE INSTALLED PROPERLY...........IF DURING THE TESTS IF 1 WIRE FAILS TO OPERATE ITS FUNCTION CHECK: CONNECTION, FUSES, AND RELAYS.

6. AFTER PLUGGING THE 3 PIN HARNESS BACK INTO THE MAIN MODULE, MAKE SURE THAT IN THE 3 PIN HARNESS HAS THE WIRES IN THE PROPER ORDER, FROM LEFT TO RIGHT, YELLOW/BLACK FIRST, THEN THE WHITE, AND THEN, THE WHITE/BLACK..................THIS IS THE WAY THEY SHOULD LINE UP IN THE PLUG.

Up ] Clearing E-Prom on RS-602E ] Type C - Door Locks ] After Market Actuators ] Trunk Popup Actuators ] E-prom 791 bypass ] E-prom all remote starters ] ERASING MEMORY ON PRO ALARMS ] [ Relay Harness Test ] Troubleshooting the 1402 ] Troubleshooting the 721 module-Passlock 1 ] Troubleshooting the 721 module-Passlock 2 ] Troubleshooting the 781 module-VATS ] Troubleshooting the 781 module-Passlock 1 ] Troubleshooting the 781 module-Passlock 2 ] Troubleshooting the 781 module-Transponder ] Tach Setting for Remote Starters ] RS1100, 1200 and 1300 Test ] Clearing Memory EPROM on Deluxe Units ]