PLACE ALL OF THESE WIRES TO A SOLID GROUND NEGATIVE DOOR PIN INPUT (BLACK/YELLOW) WIRE THE MAJOR SHOCK INPUT (YELLOW) WIRE THE MINOR SHOCK INPUT (GREEN) WIRE PRESS THE OVERRIDE (valet) SWITCH THE ALARM WILL CHIRP (3) TIMES NOW THE TRANSMITTER SHOULD NOT WORK, NEXT UNPLUG THE UNIT FROM THE MAIN HARNESS DISCONNECT WIRES FROM GROUND WAIT APROX. 1 MIN. PLUG UNIT INTO MAIN HARNESS, AND TRY TRANSMITTERS THE UNIT IS NOW BACK TO FACTORY SETTINGS.

TECH SUPPORT.

[ Up ] [ Clearing E-Prom on RS-602E ] [ Type C - Door Locks ] [ After Market Actuators ] [ Trunk Popup Actuators ] [ E-prom 791 bypass ] [ E-prom all remote starters ] [ ERASING MEMORY ON PRO ALARMS ] [ Relay Harness Test ] [ Troubleshooting the 1402 ] [ Troubleshooting the 721 module-Passlock 1 ] [ Troubleshooting the 721 module-Passlock 2 ] [ Troubleshooting the 781 module-VATS ] [ Troubleshooting the 781 module-Passlock 1 ] [ Troubleshooting the 781 module-Passlock 2 ] [ Troubleshooting the 781 module-Transponder ] [ Tach Setting for Remote Starters ] [ RS1100, 1200 and 1300 Test ] [ Clearing Memory EPROM on Deluxe Units ]