CLEARING E-PROM ON RS-602E

 

PRESS AND HOLD BUTTON (4) STOP BUTTON WHILE AT THE SAME TIME TYING THE HOOD PIN WIRE (BLACK/BLUE), THE DOOR PIN INPUT WIRE (BLACK/YELLOW) AND THE AUXILIARY INPUT WIRE (BLUE) TOGETHER AND TOUCH TO BODY GROUND.

THE PARKING LIGHTS WILL FLASH THREE(3) TIMES.

NEXT REMOVE THE WIRES FROM GROUND, RELEASE STOP BUTTON, AND TRY THE REMOTE, IT SHOULD NOT RESPOND, UNPLUG THE UNIT FROM POWER WAIT.

SEE NOTE :

WAIT 1MIN. PLUG BACK IN AND TRY AGAIN.

---------------------------------------------------------------------------------

NOTE

TO RE-PROGRAM DOOR-PIN TYPE, FIRST DETERMINE DOOR TYPE (- OR +). THEN HOLD BLACK/YELLOW WIRE TO A CONSTANT (- OR +) DEPENDING ON DOOR TYPE. WHILE HOLDING WIRE, PLUG 18-PIN HARNESS BACK IN AND TRY REMOTE.

Up ] [ Clearing E-Prom on RS-602E ] Type C - Door Locks ] After Market Actuators ] Trunk Popup Actuators ] E-prom 791 bypass ] E-prom all remote starters ] ERASING MEMORY ON PRO ALARMS ] Relay Harness Test ] Troubleshooting the 1402 ] Troubleshooting the 721 module-Passlock 1 ] Troubleshooting the 721 module-Passlock 2 ] Troubleshooting the 781 module-VATS ] Troubleshooting the 781 module-Passlock 1 ] Troubleshooting the 781 module-Passlock 2 ] Troubleshooting the 781 module-Transponder ] Tach Setting for Remote Starters ] RS1100, 1200 and 1300 Test ] Clearing Memory EPROM on Deluxe Units ]